JRC NCR-333 - Periodic Inspection; Confirming the Rx Station and Message Type; Confirming the Alert;Alarm Status

7. 2 Periodic Ins ection
Regarding the functions for performing self-diagnosis and monitoring the system status, please
refer to "6.3.5 MAINTENANCE menu(MAINTENANCE)"
I 7.2.1 Confirming the RX station and Message type
To check the receiving station and message type, please refer to 6.1.3 and 6.3.2. Be sure to set
up the receiving station and message type
correctly.
I 7 .2.2 Confirming the Alert I Alarm Status
(A) When connected to the BAM
With referring 6.3.5.2(A), confirm that
failure alert is not occurring. If any alert occurs, check the
cause
of the alert. NCR-333 Alert Table is followings.
NCR-333 Alert Table
Failure alert list (ALF sentence output)
Alert ID Indication
Alarm
Occurrence Conditions
3079,1 Built in self test failure After carrying out self-diagnosis, NCR-333 detected
3079,2 General failure
that the input voltage was abnormal.
3079,1 Built
in self test failure
After carrying out self-diagnosis, NCR-333 detected
3079,3 Antenna inoperative
that the output
voltage of antenna terminal was low
voltage.
3079,1 Built
in self test failure
After carrying out self-diagnosis, NCR-333 detected
3116,1 518kHz inoperative
that the receiver 1 (518kHz)
could not receive
because of
abnormalities.
3079,1 Built
in self test failure
After carrying out self-diagnosis, NCR-333 detected
3116,2
490kHz inoperative
that the receiver 2
(490kHz) could not receive
because of
abnormalities.
3079,1
Built
in self test failure After carrying out self-diagnosis, NCR-333 detected
3116,3 4.2MHz inoperative
that the receiver 3 (4209.5kHz)
could not receive
because of
abnormalities.
3079,2 General failure
The input voltage is low level.
3079,5
Rx unit modem error
The receiver 1 (518kHz)
could not receive because
3116,1 518kHz inoperative
of internal MODEM failure.
3079,5
Rx unit modem error The receiver 2 (490kHz) could not receive because
3116,2
490kHz inoperative
of internal MODEM failure.
3079,5
Rx unit modem error
The receiver 3
(4209.5kHz) could not receive
3116,2 4.2MHz inoperative
because of
internal MODEM failure.
3079,3
Antenna inoperative
The output
voltage of antenna terminal is low
voltage.
3079,4
Flash
memory error The flash memory data is abnormal.
3079,6 Printer
error
External printer is abnormal.
7-2