(B) When not connected
to
the BAM
With referring 6.3.5.2(B), confirm that
failure alarm is not occurring.
If
any alarm occurs, check the
cause
of
the alarm. NCR-333 Alarm Table is followings.
NCR-333 Alarm Table
Failure alarm list (ALR sentence output)
Alarm Indication
Alarm
Occurrence Conditions
No.
005 Built in self test failure
After carrying out self-diagnosis, NCR-333 detected
006 General failure
that the input voltage was abnormal.
005 Built
in self test failure
After carrying out self-diagnosis, NCR-333 detected
051
Antenna malfunction
that the output voltage of antenna terminal was low
voltage.
004
Receiver malfunction
After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 1 (518kHz) could not receive
056 Receiver 1 malfunction
because
of
abnormalities.
004 Receiver malfunction
After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 2 (490kHz) could not receive
057 Receiver 2 malfunction
because
of
abnormalities.
004 Receiver malfunction After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 3 (4209.5kHz) could not receive
058 Receiver 3 malfunction
because
of
abnormalities.
006
General failure
The input voltage
is
low level.
053
Rx
unit modem error
The receiver 1 (518kHz)
could not receive because
056 Receiver 1 malfunction
of internal MODEM failure.
053
Rx
unit modem error
The receiver 2
(490kHz) could not receive because
057 Receiver 2 malfunction
of internal MODEM failure.
053
Rx
unit modem error The receiver 3 (4209.5kHz) could not receive
058 Receiver 3 malfunction
because of internal MODEM failure.
051
Antenna malfunction The output voltage
of
antenna terminal is low
voltage.
052 Flash
memory error
The flash memory data
is
abnormal.
054 Printer
error
External printer is abnormal.
055
EXT SIO output error
•DISP~
output port
is
abnormal.
7-3
To Next Page
Loading...
