Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
- Time
Settings for the time of the internal system clock. If this button is pressed, a submenu is
recalled for setting the time and display format (see page 130).
- Password
Change administrator password for access to the system page. If this button is pressed, a
submenu is recalled for setting the password (see page 135-136).
This setting can also be recalled if the system page is not password protected. In this case,
it is possible to set the password in the event that the password protection should be
activated via the ETS at a later date.
- Programming mode
Activating and deactivating the KNX programming mode. If this button is pressed, the
programming mode is recalled (see page 136-137).
- Version:
Display of the current device firmware. The button only acts as a display element. Pressing
this button produces no reaction.
Time and date
The time and date can be set separately from each other in the administration area of the
device. Depending on which button was pressed in the overview of the system page (1.), the
display either branches to the date setting (figure 62) or to the time setting (figure 63).
By pressing the "Z Admin area" button you return to the system page (2.) without any changes.
Page 130 of 347
Software "Smart Control 501511"
Functional description

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English