}
}
}
}
}
}
Configuring the Maintenance Intermediate Points with Circuit Cross-Connect when Maintenance
Association End Point is Configured
In ACX5048 and ACX5096 routers, you can configure the MIP with circuit cross-connect
(CCC) when a maintenance association end point (MEP) is configured. The following is
a sample to configure the MIP with CCC when MEP is configured:
[edit protocols]
oam {
ethernet {
connectivity-fault-management {
maintenance-domain md2 {
level 5;
mip-half-function default;
maintenance-association ma2 {
continuity-check {
interval 1s;
}
mep 222 {
interface xe-0/0/42.0;
direction up;
}
}
}
}
}
}
Related
Documentation
bridge-domain•
• connectivity-fault-management
• instance
• mip-half-function
• IEEE 802.1ag OAM Connectivity Fault Management Overview
• Creating a Maintenance Domain
• Creating a Maintenance Association
• Configuring Continuity Check Protocol Parameters for Fault Detection
• Configuring a MEP to Generate and Respond to CFM Protocol Messages
• Configuring a CFM Action Profile to Specify CFM Actions for CFM Events
• Configuring Linktrace Protocol in CFM
• Configuring Ethernet Local Management Interface
Copyright © 2017, Juniper Networks, Inc.1132
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
