For example:
[edit interfaces ds-1/0/0:1:1:1 ]
user@host# set encapsulation cesopsn unit 0
To verify this configuration, use the show command at the [edit interfaces ds-1/0/0:1:1:1]
hierarchy level.
[edit interfaces ds-1/0/0:1:1:1]
user@host# show
encapsulation cesopsn;
unit 0;
Related
Documentation
Understanding Mobile Backhaul•
• Configuring CESoPSN Encapsulation on DS Interfaces on page 215
Configuring CESoPSN Encapsulation on DS Interfaces
This configuration applies to the mobile backhaul application shown in Mobile Backhaul
Application.
1.
Setting the Encapsulation Mode on page 215
2.
Setting the CESoPSN Options on page 216
3.
Configuring the Pseudowire Interface on page 217
Setting the Encapsulation Mode
To configure a DS interface on Circuit Emulation MICs with CESoPSN encapsulation at
the provider edge (PE) router:
1. In configuration mode, go to the [edit interfaces ds-mpc-slot/mic-slot/port<:channel>]
hierarchy level.
[edit]
user@host# edit interfaces ds-mpc-slot/mic-slot/port<:channel>
For example:
[edit]
user@host# edit interfaces ds-1/0/0:1:1:1
2. Configure CESoPSN as the encapsulation type and set the logical interface for the
DS interface.
[edit interfaces ds-mpc-slot/mic-slot/port<:channel>]
user@host# set encapsulation cesopsn unit logical-unit-number
For example:
[edit interfaces ds-1/0/0:1:1:1]
user@host# set encapsulation cesopsn unit 0
215Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Configuring CESoPSN Support on Interfaces
To Next Page
Loading...
Need help?
General
