Juniper ACX1000 Configuration Guide

8. Configure the IGMP message intervals and robustness count.
[edit bridge-domains domain1]
user@host# set protocols igmp-snoopingrobust-count 4
user@host# set protocols igmp-snooping query-last-member-interval 0.1
user@host# set protocols igmp-snooping query-interval 200
user@host# set protocols igmp-snooping query-response-interval 0.4
9. If you are done configuring the device, commit the configuration.
user@host# commit
Results Confirm your configuration by entering the show bridge-domains command.
user@host# show bridge-domains
domain1 {
domain-type bridge;
interface ge-0/0/1.1;
interface ge-0/0/2.1;
interface ge-0/0/3.1;
protocols {
igmp-snooping {
query-interval 200;
query-response-interval 0.4;
query-last-member-interval 0.1;
robust-count 4;
immediate-leave;
proxy;
interface ge-0/0/1.1 {
host-only-interface;
group-limit 50;
}
interface ge-0/0/3.1 {
static {
group 225.100.100.100;
}
}
interface ge-0/0/2.1 {
multicast-router-interface;
}
}
}
}
Verification
To verify the configuration, run the following commands:
•
show igmp snooping interface
•
show igmp snooping membership
•
show igmp snooping statistics
485Copyright © 2017, Juniper Networks, Inc.
Chapter 15: Configuring Internet Group Management Protocol Snooping

Juniper ACX1000 Specifications

General

Brand	Juniper
Model	ACX1000
Category	Network Router
Language	English