KAESER M 64 - Changing the Cooling Oil

10.4.3 Changing the cooling oil
Drain the oil completely from the following components:
■
Oil separator tank
■ Oil cooler
■ Oil pipes
■ Heat exchanger (Option db)
➤ Always change the oil filter when changing the oil.
Material Cooling oil
Receptacle
New gasket for the drain plug
Funnel
Cleaning cloth
Precondition The machine is shut down.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 bar.
The machine is at operating temperature.
All compressed air consumers are disconnected and the air outlet valves are open.
Negative cable to the batteries disconnected.
CAUTION
There is risk of burns from hot components and escaping oil.
➤
Wear long-sleeved clothing and gloves.
➤ Open the right-hand access door.
10.4.3.1 Draining the cooling oil
The cooling oil is drained directly at the oil separator tank and the oil cooler.
10 Maintenance
10.4 Compressor Maintenance
124
Operator manual Portable compressor
M 64
No.: 9_5898 26 E
RAMIRENT