KAESER M 64 - Special Measures for Re-Commissioning after Storage or De-Commissioning; Checking Installation and Operating Conditions; Tab. 67 Measures for Re-Commissioning the Compressor after a Long Period of Storage or De-Commissioning; Tab. 68 Positioning and Operating Conditions Checklist

7.2.2 Special measures for re-commissioning after storage or de-commissioning
➤ Carry out the following before every start-up after long period of storage or de-commissioning:
Storage/de-
commissioning
period longer
than:
Remedy
5 months ➤ Remove the desiccant from the openings in the air intake filters of the en‐
gine and compressor.
➤
Check the air and oil filters.
➤ Drain the preserving oil from the separator tank.
➤ Fill with cooling oil.
➤ Drain the preserving oil from the engine.
➤ Fill up with engine oil.
➤ Check the engine coolant level.
➤ Check the battery charge state.
➤ Reconnect the battery.
➤ Check all fuel lines, engine oil lines and compressor cooling oil lines for
leaks, loose connections, wear and damage.
➤ Clean the bodywork with a grease and dirt dissolving agent.
➤ Check the tyre pressures.
36 months ➤ Have the overall technical condition checked by an authorised
KAESER SERVICE technician.
Tab. 67 Measures for re-commissioning the compressor after a long period of storage or de-commissioning
7.3 Checking installation and operating conditions
➤ Check and confirm all the items in the checklist before starting the machine.
Check See chapter Confirmed?
➤ Are the operators fully conversant with safety regulations? –
➤ Have all the positioning conditions been fulfilled? 5
➤ Is there sufficient cooling oil in the separator tank? 10.4.1
➤ Is there sufficient oil in the engine? 10.3.4
➤ Is the maintenance indicator on the air intake filters (engine and
compressor) OK?
10.3.2,
10.4.7
➤ Is there sufficient coolant in the coolant expansion tank? 10.3.1
➤ Is there sufficient fuel in the fuel tank? –
➤ Is there sufficient tool oil in the tool lubricator? (Option ec) 10.7.1
➤ Is there enough antifreeze in the frost protector? (Option ba) 10.7.5
➤ Are the access doors closed and all body panels in place? –
➤ Are the tyre pressures OK? –
Tab. 68 Positioning and operating conditions checklist
7 Initial Start-up
7.3 Checking installation and operating conditions
No.: 9_5898 26 E
Operator manual Portable compressor
M 64
61
RAMIRENT