EasyManua.ls Logo

KAESER M 64 - Engine Does Not Reach Full Speed; Indicator Lamp Remains on; Tab. 71 Fault: Engine Refuses to Start or Comes to a Stop; Tab. 72 Alarm: Engine Does Not Reach Full Speed

KAESER M 64
344 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Possible cause Remedy Where can I get help?
SW KS
Defective alternator regulator. Have repaired or replaced if
necessary.
X X
Oil pressure switch indicating in‐
sufficient oil pressure.
Check engine oil level, see
chapter 10.3.4
.
X X
Have the engine repaired or ex‐
changed.
X X
SW = specialised workshop; KS = KAESER SERVICE
Tab. 71 Fault: engine refuses to start or comes to a stop.
9.2.2 Engine does not reach full speed
Possible cause Remedy Where can I get help?
SW KS
Airlock in the fuel line between
fuel tank and injector pump.
Bleed the fuel line (see chap‐
ter 10.3.3).
– –
Fuel filter clogged. Clean or replace, see chap‐
ter 10.3.3.
X X
Fuel line broken. Have changed. X X
Speed adjustment cylinder mal‐
adjusted or defective.
Repair or have replaced if nec‐
essary.
X X
SW = specialised workshop; KS = KAESER SERVICE
Tab. 72 Alarm: "engine does not reach full speed".
9.2.3 Indicator lamp remains on
Possible cause Remedy Where can I get help?
SW KS
Electrical connections and/or ca‐
bles loose or broken
Tighten the connection or have
the cable replaced.
X X
Motor alternator defective. Have repaired or replaced if
necessary.
X X
Defective alternator regulator. Have repaired or replaced if
necessary.
X X
Engine oil pressure too low. Check engine oil level, see
chapter 10.3.4
.
– –
Check the engine and have re‐
paired, if necessary.
X X
SW = specialised workshop; KS = KAESER SERVICE
Tab. 73 Alarm: "Control lamp remains on"
9 Fault Recognition and Rectification
9.2 Evaluating engine faults and alarms
84
Operator manual Portable compressor
M 64 No.: 9_5898 26 E
RAMIRENT

Table of Contents