Instructions for use ELECTROmatic TM and TMM/TMC
6 Operation | 6.4 PREP mode
58 / 90
ð The set value is being saved.
Requirement
Two motors are connected.
▶ Press the control element, "Transmission ratio".
ð The display shows a selection list.
▶ Select the transmission ratio from the selection list. Scroll the selection list
up or down and select the transmission ratio.
ð The transmission ratio is shown on the display, presently: 1:1.
ð The set value of the transmission ratio is being saved along with the selec-
ted speed (presently 1,000 min
-1
/rpm).
Note
If a transmission ratio of 1:1 is selected, a motor speed of 40,000 min
-1
/rpm
is shown. To display the speed of the clamped tool, the transmission ratio of
the handpiece in use needs to be selected.
Note
If the COMFORTdrive is connected, the device recognises the COMFORTdrive
and the display shows "200XD" instead of the transmission ratio.
6.4.2 Changing the direction of rotation
▶ Press the control element, "Direction of motor rotation".
ð The direction of motor rotation changes.
ð The symbol on the display indicates the direction of motor rotation.
To Next Page
Loading...
Need help?
General
