KEB COMBIVERT F4-F Applications Manual

ANTRIEBSTECHNIK
611 1
KEB COMBIVERT F4-F
Name: Basis
17.06.99
Functional Description
Chapter Section PageDate
© KEB Antriebstechnik, 1999
All Rights reserved
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Applications
13. Annex
6.1 Operating and Unit Datas
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Motor Data and Controller
Adjustment
6.6 Keep on Running Functions
6.7 Parameter Sets
6.8 Special Functions
6.9 Encoder Interface
6.10 Synchronous Control
6.11 Positioning Module
6.12 CP-Parameter Definition
6.11.1 Activating Positioning Module 3
6.11.2 Adjustment/Display Mode of
Position Values (Pc.1) ............ 4
6.11.3 Setpoint/Actual Position and
Position Setting (Pd.8..10,
ru.35..40) ............................... 4
6.11.4 Position Setting in Revolutions 5
6.11.5 Position Setting in Increments 6
6.11.6 Software Limit Switch (Pc.4..9)6
6.11.7 Relative/Absolute
Positioning ............................. 8
6.11.8 Target Window (Pd.12) .......... 8
6.11.9 Cancel positioning ................. 8
6.11.10 Selection of Encoder Input for
Position Feedback (Pc.16) ..... 8
6.11.11 Gear Factor for Encoder Input
2 (Pc.17) ................................ 9
6.11.12 Profile of Speed Precontrol
(Pd.3, Pd.5..7) ....................... 9
6.11.13 Optimizing Position Controller
(Pd.2) ................................... 10
6.11.14 Teach-Function (Pd.1) ......... 10
6.11.15 Reference Point Approach ... 11
6.11.16 Reference Point Approach
(Examples) .......................... 12
6.11.17 Adjustment of Positioning
Controller and Drive Profile.. 15
6.11.18 Check List ............................ 17
6.11.19 Programming Examples ...... 18
6.11.20 Used Parameters ................. 25

KEB COMBIVERT F4-F Specifications

General

Brand	KEB
Model	COMBIVERT F4-F
Category	Lifting Systems
Language	English