KEB COMBIVERT F4-F Applications Manual

3
ANTRIEBSTECHNIK
4
33
KEB COMBIVERT F4-F
Name: Basis
15.12.98
4
CP - Parameter
© KEB Antriebstechnik, 1998
All Rights reserved
Operation
Chapter Section PageDate
4.3.1 Operation in
CP-Mode
4.3 CP-Parameter
The Customer-Parameters (CP) are a special group of parameter. With the
exception of CP.0 (Password input), they can be defined by the user. The following
Parameters are preset at delivery.
Advantages from it: - operator-friendly for the customer
- critical parameters are protected against maloperation
- low documentation cost for the machine builder
FUNCT
SPEED
▲
START
▼
STOP
▲
START
▼
STOP
Adjustment of
parameter number
Adjustment of
parameter value
Compared to the Application-Mode the operation in the CP-Mode is easier because
parameter set selection and parameter group selection are unnecessary.
The following list shows the CP-parameter group predefined by us. The definition
of the CP-parameters is done in the User-Definition-Parameters (ud). How you can
define your own parameters is described in Chapter 6.12 „CP-Parameter Definiti-
on“.
4.3.2 Factory Setting

KEB COMBIVERT F4-F Specifications

General

Brand	KEB
Model	COMBIVERT F4-F
Category	Lifting Systems
Language	English