10
Identification
1．The identification number of motorcycle frame is
marked at :
*LBBTEBAA?????????. The 10
th
digital and
11
th
digital respectively indicate year code and factory code. “*”
shall be added before and after the frame number. The frame sign
is nailed at . See Fig. 1-1.
Fig. 1-1
2．The engine serial number is printed on the shell of
crankcase. See fig. 1-2.
Fig. 1-2
Significant Notes
1. Please apply valid Qianjiang parts and accessories. Any part or accessory not in accordance with the design
specification of Qianjiang Company may cause damage to engine.
2. Only metric tools are valid for maintenance and repair. Metric screws, bolts and nuts can not be exchanged with
imperial fasteners.
3. New gaskets, O-rings, cotter pins and locking pieces shall be applied for re-assembly.
4. Bolts with large diameter or positioned inside shall be fastened first and then diagonally screw down until
reaching required torque, otherwise there is special instruction.
5. Wash disassembled parts with cleanser. Lubricate all sliding surface before assembly.
6. Check whether all the parts and accessories are correctly mounted and operated after assembly.
7. Clean and remove oil before measurement. Add recommended lubricant to the lubricating areas during assembly.
8. Apply lubricant to the surface of engine and driving system if they are dismantled for long-term storage, which
can prevent rust and dirt.
To Next Page
Loading...
Need help?
General
