95
• Bearings must be pressed in horizontally.
7.3.4 Installation
Install it in reverse order.
Instructions:
Lubricate the front wheel spindle, gear housing assembly, oil
seal (opening), spindle sleeve, bearing 6201-2RS and middle
spindle sleeve assembly.
Albany grease is suggested.
Install the front wheel spindle（1）, front wheel, gear housing assembly（8）
and nut M10Χ1.25（9）.
When the gear housing assembly（8）is installed, the
odometer gear housing assembly shall be aligned well. If
the front wheel spindle is not well aligned and locked,
the odometer housing assembly will be deformed.
Install the brake cylinder assembly on the front rim.
Tighten the front wheel spindle (shown in the right
picture).
* Note: for the disassembly and assembly of the front
suspension of FACT 50 4T, please see P88.
Torque force:
Locking nuts for the front wheel spindle 55-62 N·m
7.4 Steering handle
7.4.1 Disassembly
Remove the rearview mirror assembly.
Remove the fixing screws of the decorating covers of the upper/lower handlebar shade.
Remove the decorating cover of the upper handlebar
cover, and then the meter.
Remove the front shade assembly.
Remove the left/right combined switch assembly.
Remove the fuel pump assembly.
Remove the left grip and the throttle lever assembly.
Loosen the fixing bolt (2) and nut (3) of the handlebar
weld assembly.
Remove the handlebar weld assembly（1）.
7.4.2 Installation
* Note: for the disassembly and assembly of the
handlebar, please see P90.
To Next Page
Loading...
Need help?
General
