EasyManuals Logo

KEEWAY FACT 50 4T User Manual

KEEWAY FACT 50 4T
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
50
Brake to the maximum and check the oil level through the oil sight glass. In case the brake fluid level is at or below
the arrow in the picture, certain brake fluid shall be added until it reaches the upper limit.
Note:
The fuel pump assembly shall be parallel with the ground during inspection.
Headlamp
Remove the front shield.
Disconnect the connector of the headlamp.
Remove the headlamp.
(前大灯:headlamp)
Clutch
Start the engine and increase its speed gradually to check the
work condition of the clutch. If the motorcycle fails to run or
the engine flames out, you should check the clutch block.
Replace it if necessary.
Front/rear suspension system
Front
Pull the front brake tight; compress the front absorber
upwards or downwards for check.
Check whether there is oil leakage in the front absorber and

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KEEWAY FACT 50 4T and is the answer not in the manual?

KEEWAY FACT 50 4T Specifications

General IconGeneral
BrandKEEWAY
ModelFACT 50 4T
CategoryMotorcycle
LanguageEnglish

Related product manuals