K-MIX EDITOR
114
• When disabled, all audio will be routed out outputs 1–8 as normal.
It is important to note that when both surround panning and bass management are enabled, the
headphone output can no longer be used for monitoring input and output channels; it is solely
dedicated to the low frequency content.
The settable options are as follows:
ON/OFF SWITCH
The on/off switch enables or disables K-Mix’s bass management when surround panning is enabled.
• ON = Bass management is enabled
• OFF = Bass management is disabled
CROSSOVER FREQUENCY
Sets the center frequency of the crossover.
• Audio below the crossover frequency will be routed out the headphone jack.
• Audio above the crossover frequency will be routed out outputs 1–8 as normal.
• Range: 40Hz – 160Hz
5.2.3.4 – SURROUND PANNERS
The surround panners are used to spatialize/move sounds between
speakers in the selected surround sound format.
• The blue dots along the edge of the panners represent the speaker
placement of the selected surround format. Each speaker is labelled
with a number representing the K-Mix output channel that speaker’s
audio signal will be sent out on.
• The four panners mirror the behavior of K-Mix’s four rotary encoders
when in surround panning mode.
• Clicking a surround panner while holding down the COMMAND key will instantly reset the panner
to center.
5.2.3.5 – SURROUND PANNER ASSIGNMENT BUTTONS
Used to assign the input channels to one of the four rotaries.
• Once an input channel is assigned, the associated surround
panner (and rotary on the K-Mix hardware) will be used to
pan that channel’s audio in the surround eld.
• It is not possible to have a channel unassigned.
These are editor-only parameters. They may not be adjusted from the mixer.
1
2
34
CH. 1 CH. 2 CH. 3 CH. 4
CH. 5 CH. 6 CH. 7 CH. 8
To Next Page
Loading...
Need help?
General