Keith McMillen Instruments K-MIX - To Power

GETTING STARTED
16
2.3.1 – TO POWER
K-Mix can be powered in one of two ways:
BUS-POWERED VIA COMPUTER
The most convenient way to power K-Mix is via USB bus-power from a connected computer, tablet, or
other USB host device.
1. Connect a micro-USB cable to K-Mix’s AUDIO port on the back panel.
2. Connect the other end of the micro-USB cable to a powered USB port on a computer.
3. Turn on K-Mix by pressing the [ ] button.
ar = 44100
kr = 4410
ksmps = 10
nchnls = 8
/*-------IVORY-------*/
instr
1
ifreq
=
cpspch(p5)
aglis
expseg
1, p8, 1, p3 - p8, p9
k1
line
0, p3, 5
k2
oscil
k1, p7, 1
k3
linseg
0, p3 * .7, p6, p3 * .3, 0
a1
oscil
k3, (ifreq + k2) * aglis, 1
k4
linseg
0, p3 * .6, 6, p3 * .4, 0
k5
oscil
k4, p7 * .9, 1, 1.4
k6
linen
p6, p3 * .5, p3, p3 * .333
a3
oscil
k6, ((ifreq + .009) + k5) * aglis, 9, .2
It is possible that some devices will not be capable of bus-powering K-Mix on their
own. If this is the case then you will need to power K-Mix externally for K-Mix to fully
operate.