GETTING STARTED
11
2.1.1.5 – DIAMOND PAD
The diamond buttons are used to select whether K-Mix is in the “Mix” bank,
or one of three available MIDI banks (“1”, “2”, “3”); they can also be used to
output MIDI notes and transport control messages.
2.1.1.6 – POWER BUTTON
The [ ] is used to turn K-Mix on and off.
2.1.1.7 – MIXER/INTERFACE INDICATOR LEDS
Two LEDs below K-Mix’s [ ] button show whether K-Mix is currently powered on
or not. If on, these will be illuminated; if off, these will be off.
2.1.1.8 – MODE BUTTONS
The mode buttons are used to switch the current “mode” your K-Mix is
in. Each mode allows access to different audio-related parameters, such
as EQ, Gate, Compressor, etc.
2.1.1.9 – PRESET BUTTON
Used to select which of the 12 onboard presets is currently loaded.
2.1.1.10 – PHANTOM POWER INDICATOR LEDS
Used to indicate the current phantom power states for channels 1 and 2.
2.1.1.11– HEADPHONE OUTPUT JACK
At the very front of K-Mix is a 1/8” stereo headphone output jack. Plug
in your headphones to monitor outputs and inputs. The headphone jack
can also function as its own discrete stereo output bus, or be used as a
low frequency crossover output when mixing in surround.
Mixer
Interface
Mixer
Interface
To Next Page
Loading...