Keith McMillen Instruments K-MIX User Manual

K-MIX HARDWARE
52
3. Tap the top of the same fader to solo the channel.
4. Steps 2 and 3 can also be done in reverse order.
VISUAL FEEDBACK
When a channel is both muted and soloed, the channel select button will blink yellow.
4.2.7.6 – STEREO PAIRING
K-Mix channels 1 and 2, 3 and 4, 5 and 6, and/or 7 and 8 can be paired into stereo channels. Once
paired, their parameters sync up and follow each other if any of them are adjusted. To enable stereo
pairing for one of the pairs:
1. Press and hold the [SHIFT] button.
2. Press anywhere on a rotary above the two channels you wish to pair (rotary 1 for channels 1 and 2,
rotary 2 for channels 3 and 4, etc.).
4.2.7.7 – [SHIFT] FUNCTIONALITY
When in Mains Mode, the [SHIFT] button is used for muting and soloing audio channels and for
enabling or disabling stereo pairs.
• Hold down the [SHIFT] button and tap the bottom of a fader to mute the selected channel.
• Hold down the [SHIFT] button and tap the top of a fader to solo the selected channel.
• Hold down the [SHIFT] button and tap a rotary to pair the two channels directly below the rotary.

Keith McMillen Instruments K-MIX Specifications

General

Brand	Keith McMillen Instruments
Model	K-MIX
Category	Music Mixer
Language	English