K-MIX EDITOR
115
• An input channel may only be assigned to a single rotary at a time. They cannot be assigned to
multiple panners simultaneously.
• When a channel is assigned to a panner, its button will be white.
• When a channel is not assigned to a panner, its button will be black.
5.2.3.6 – SAVE GLOBALS BUTTON
Used to save the current state of all global settings to the K-Mix hardware’s internal memory.
Any changes made in the editor to “global” parameters (parameters that are not stored on a per preset
basis) will be immediately reected and heard on the connected mixer, but they will not be stored in its
internal memory. If power is lost and the K-Mix is turned on again, all changes will be lost; it will boot up
with its last saved state. When you have found settings you would like to keep, it is wise to use the Save
Globals button to make sure your global settings are not forgotten.
The other method to make sure your global settings are remembered between power cycles is to
power down your K-Mix by holding down the [ ] for three seconds. Powering down in this manner will
ensure all global settings are saved to your K-Mix’s internal memory; simply unplugging your K-Mix from
its power source will not do this. More information about global parameters can be found in section
5.1.1.10 – “Global” Parameters vs. “Per Preset” parameters.
This is an editor-only parameter. It may not be adjusted from the mixer.
SAVE GLOBALS
To Next Page
Loading...
Need help?
General