K-MIX EDITOR
117
5.2.4.2 – MIDI PARAMETERS SECTION
Displays and sets the editable MIDI parameters for the currently selected
fader/button/rotary.
• Each sensor can be set to output a different MIDI message for each of
the three available MIDI banks.
• Duplicate MIDI messages are not allowed. Sensors may not be set with
the same CC/Note and MIDI channel.
FADERS
Each of the K-Mix faders can output a CC message when in one of the
three available MIDI banks.
• The faders can be set to output any MIDI CC from 0–127.
BANK 1 CC#
Sets the CC number the currently selected fader will send when in bank 1.
BANK 2 CC#
Sets the CC number the currently selected fader will send when in bank 2.
BANK 3 CC#
Sets the CC number the currently selected fader will send when in bank 3.
BUTTONS
Each button (except the Power and Shift buttons) can output a MIDI note
message when in one of the three available MIDI banks.
• By default, the buttons will behave like a “momentary” button; when
the button is pressed it sends a note on message, when the button is
released it sends a note off message.
• Buttons can also be set to toggle. The rst press will turn the note
on, the second press will turn the note off.
• Each button can be set to output any MIDI note from 0–127.
BANK 1 NOTE#
Sets the note number the currently selected button will send when in
bank 1.
BANK 2 NOTE#
Sets the note number the currently selected button will send when in bank 2.
BANK 3 NOTE#
Sets the note number the currently selected button will send when in bank 3.
Bank 1 CC#
Bank 2 CC#
Bank 3 CC#
CHANNEL 1 FADER
1
2
3
Bank 1 Note#
Bank 2 Note#
Bank 3 Note#
MOMENTARY
BUTTON 1
1
2
3
To Next Page
Loading...
Need help?
General