K-MIX HARDWARE
73
• CC values are ranged from 0 (minimum) to 127 (maximum). 0 is at the bottom of the fader; 127
is at the top of the fader.
• The fader LEDs display the current value/location of the fader.
ROTARIES
K-Mix’s rotaries behave like traditional knobs when in the MIDI banks.
• Each rotary outputs its current location as a MIDI CC message.
• The specic CC each rotary outputs is set in the K-Mix Editor’s MIDI Tab.
• CC values are ranged from 0 (minimum) to 127 (maximum).
• 0 (minimum) = approximately 7 o’clock; 127 (maximum) = approximately 5 o’clock. There is a
“dead zone” at the bottom of the rotary (6 o’clock position).
• Move the rotary clockwise to increase its value; move the rotary counterclockwise to decrease
its value.
• The rotary LEDs display the current value/location of the fader.
BUTTONS
K-Mix’s buttons can behave in two different ways when in MIDI banks; they can act as momentary
switches or toggle switches.
• Buttons always output MIDI notes.
• The specic MIDI note each button outputs, and whether the button is a momentary switch or
toggle switch, is set in the K-Mix Editor’s MIDI Tab.
• When set to “momentary”, the button will output a MIDI note with a velocity of 127 when
pressed, then output a MIDI note with a velocity of 0 when released.
• When set to “toggle”, the button will output a MIDI note with a velocity of 127 the rst time the
button is pressed (toggled on), then output a MIDI note with a velocity of 0 the next time it is
pressed (toggled off).
• The button’s LED will light up when pressed (or toggled on), and will turn off when released (or
toggled off).
To Next Page
Loading...
Need help?
General