Keithley 2010 Service Manual

M
Main CPU firmware replacement 5-7
Manufacturing calibration 2-20
Manufacturing calibration commands B-14
Measuring synthesizer signal amplitude 2-24
Memory circuits 4-7
Microcontroller 4-6
Microprocessor 4-6
Miscellaneous calibration commands B-4
Motherboard removal 5-5
Multiplexer and A/D converter 4-9
N
No comm link error 4-18
O
Ordering information 6-2
P
Parts lists 6-2
Performance Verification 1-1
Performing the verification test procedures 1-5
Power module removal 5-8
Power supply 4-4
Power supply checks 4-11
Power transformer removal 5-8
Power-on self-test 4-2
Preparing the Model 2010 for calibration 2-6,
2-14
Principles of operation 4-4
Programming calibration dates 2-19
R
Recommended equipment 2-5
Recommended test equipment 1-3, 2-20
Remote calibration 2-13
Remote command code 2-4
Remote error reporting B-14
Remote manufacturing calibration (firmware
A13 and lower) 2-25
Remote manufacturing calibration (firmware
A14 and higher) 2-23
Removing power components 5-8
Repair considerations 4-2
Replaceable Parts 6-1
Replacing the AMPS fuse 3-3
Resistance calibration 2-9, 2-16
Restoring factory defaults 1-4
Routine Maintenance 3-1
RS-232 interface 4-7
RTD temperature 1-13
S
Saving calibration constants 2-19
Setting calibration dates 2-12
Setting the line voltage and replacing the line
fuse 3-2
Short and open calibration 2-14
Signal switching 4-9
Software requirements C-2
Solder repairs 5-2
Specifications A-1
Static sensitive devices 5-3
Status byte EAV (Error Available) bit B-17
T
Test considerations 1-5
Test equipment connections 2-21
Test summary 1-5
Thermocouple temperature 1-12
Trigger circuits 4-8
Troubleshooting 4-1, 4-10
U
Unlocking manufacturing calibration 2-22
Using the *OPC command B-18
Using the *OPC? query B-17
V
Verification limits 1-4
Verification test requirements 1-2
Verifying AC current 1-9
Verifying AC voltage 1-7
Verifying DC current 1-8
Verifying DC voltage 1-6
Verifying frequency 1-14
Verifying ratio 1-14
Verifying resistance 1-10
Verifying temperature 1-12
W
Warm-up period 1-2, 2-2

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz