Keithley 2010 Service Manual

Introduction
This section contains replacement parts information and component layout drawings for the
Model 2010.
Parts lists
The electrical parts lists for the Model 2010 are shown in Tables 4-1 to 4-3. For part numbers
to the various mechanical parts and assemblies, use the Miscellaneous parts list and the
assembly drawings provided at the end of Section 5 and Table 6-1 through Table 6-4.
Ordering information
To place an order, or to obtain information concerning replacement parts, contact your Keithley
representative or the factory (see inside front cover for addresses). When ordering parts, be sure to
include the following information:
• Instrument model number (Model 2010)
• Instrument serial number
• Part description
• Component designation (if applicable)
• Keithley part number
Factory service
If the instrument is to be returned to Keithley Instruments for repair, perform the following:
• Call the Repair Department at 1-800-552-1115 for a Return Material Authorization
(RMA) number.
• Complete the service form at the back of this manual, and include it with the instrument.
• Carefully pack the instrument in the original packing carton.
• Write ATTENTION REPAIR DEPARTMENT and the RMA number on the shipping
label.
Component layouts
The component layouts are provided in the following pages:
• Motherboard: 2010-250, pages 1 and 2
• Connector board: 2010-250, pages 1 and 2
• Display board: 2010-110, pages 1 and 2
6-2 Replaceable Parts

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz