Keithley 2182 User Manual

12-12 Common Commands
*RST – Reset Return 2182 to *RST defaults
Description
When the *RST command is sent, the Model 2182 performs the following operations:
1. Returns the Model 2182 to the *RST default conditions (see SCPI tables).
2. Cancels all pending commands.
3. Cancels response to any previously received *OPC and *OPC? commands.
NOTE: For RS-232 operation (and in some cases, GPIB operation), *OPC or *OPC? should
be used with *RST, which is a slow responding command. Details on *OPC and
*OPC? are provided in Section 12.
*SAV – Save Save present setup in memory
Parameters
<NRf>=0
Description
Use the *SAVE command to save the present instrument setup configuration in memory for
later recall. Any control affected by *RST can be saved by the *SAV command. The *RCL
command is used to restore the instrument to the saved setup configuration.
Only one setup configuration can be saved and recalled.
NOTE: For RS-232 operation (and in some cases, GPIB operation), *OPC or *OPC? should
be used with *SAV, which is a slow responding command. Details on *OPC and
*OPC? are provided in Section 12.
*SRE <NRf> – Service Request Enable Program service request enable register
*SRE? – Service Request Enable Query Read service request enable register
Parameters
<NRf> = 0 Clears enable register
1 Set MSB bit (Bit 0)
4 Set EAV bit (Bit 2)
8 Set QSB bit (Bit 3)
16 Set MAV bit (Bit 4)
32 Set ESB (Bit 5)
128 Set OSB (Bit 7)
255 Set all bits

Keithley 2182 Specifications

General

Brand	Keithley
Model	2182
Category	Measuring Instruments
Language	English