Keithley 2182

List of T
ables
1 Getting Started
Table 1-1
Fuse ratings ....................................................................................................... 1-15
Table 1-2 Factory defaults ................................................................................................. 1-17
2 Voltage and Temperature Measurements
Table 2-1
Measurement channels ........................................................................................ 2-3
Table 2-2 SCPI commands - ACAL, Front Autozero, Autozero, LSYNC, and
Low Charge Injection .................................................................................. 2-10
Table 2-3 SCPI commands - voltage and temperature measurements .............................. 2-20
3 Range, Digits, Rate, and Filter
Table 3-1
SPCI commands - range ..................................................................................... 3-4
Table 3-2 SPCI commands - digits ..................................................................................... 3-5
Table 3-3 SCPI commands - rate ........................................................................................ 3-7
Table 3-4 SCPI commands - filter ..................................................................................... 3-12
4 Relative, mX+b, and Percent (%)
Table 4-1
SCPI commands - relative .................................................................................. 4-4
Table 4-2 SCPI commands - mX+b and percent ................................................................ 4-8
5 Ratio and Delta
Table 5-1
SCPI commands - ratio and delta ..................................................................... 5-16
6 Buffer
Table 6-1
SCPI commands - buffer ..................................................................................... 6-5
7 Triggering
Table 7-1
Auto delay times ................................................................................................. 7-4
Table 7-2 SCPI commands - triggering ............................................................................. 7-16
8 Limits
Table 8-1
SCPI commands - limits ..................................................................................... 8-5
9 Stepping and Scanning
Table 9-1
SCPI commands - stepping and scanning ......................................................... 9-12