Keithley 2182 User Manual

Common Commands 12-5
If a command error (CME) occurs, bit B5 of the Standard Event Status Register sets. If a
query error (QYE) occurs, bit B2 of the Standard Event Status Register sets. Since both of these
events are unmasked (enabled), the occurrence of any of them causes the ESB bit in the Status
Byte Register to set.
Read the Standard Event Status Register using the *ESE? query command.
Figure 12-1
Standard event enable register
B7 B6 B5
B4 B3
B2 B1
B0
(2 )
4
(2 )
5
1632
0/10/1
Bit Position
Event
Decimal Weighting
Value
Value : 1 = Event Bit Set
0 = Event Bit Cleared
Events : PON = Power On
URQ = User Request
CME = Command Error
EXE = Execution Error
DDE = Device-Dependent Error
QYE = Query Error
OPC = Operation Complete
PON URQ CME DDEEXE QYE OPC
(2 )
6
64
(2 )
7
128
(2 )
3
8
(2 )
2
4
(2 )
0
1
0/1 0/10/10/1 0/1
Note: Bits B8 through B15 are not shown since they are not used.

Keithley 2182 Specifications

General

Brand	Keithley
Model	2182
Category	Measuring Instruments
Language	English