Remote calibration 2-13
AC current 2-17
AC voltage 2-16
command summary B-2
DC current 2-16
DC volts 2-14
Locking out calibration 2-18
preparing the Model 2700 2-13
Programming calibration dates 2-17
resistance 2-15
Saving calibration constants 2-18
short and open 2-14
Remote error reporting B-21
Repair considerations 4-2
Replaceable Parts 6-1
resistance A-14, A-15
verifying, Model 2700 1-13
verifying, Model 7700 1-25
RS-232 interface 4-8
S
Safety Precautions 1
Scanner card signals 4-10
Signal switching 4-10
Solder repairs 5-2
Specifications A-11
Static sensitive devices 5-3
Status byte EAV (Error Available) bit B-23
Switching device locations 4-17
T
Temperature A-14, A-15
temperature
RTD, Model 2700 1-16
RTD, Model 7700 1-29
thermocouple, Model 2700 1-15
thermocouple, Model 7700
1-27
verifying, Model 2700 1-15
verifying, Model 7700 1-27
Trigger circuits 4-8
Troubleshooting 4-1
V
verification
Model 2700 1-8
Model 7700 1-18
Verification limits 1-5
Verification test
considerations 1-7
Model 2700 1-6
Model 7700 1-6
summary 1-6
verification test
procedures 1-6
Verification test requirements 1-3
verifying
AC current, Model 7700 1-24
W
W2 signal multiplexing and gain 4-17
W2 signal switching 4-14
W2/W4 reference switching 4-14
W4 signal multiplexing and gain 4-17
W4 signal switching 4-14
Warm-up period
calibration 2-2
Verification Procedures 1-3
To Next Page
