6482-901-01 Rev. A / August 2012 Return to Section Topics 1-13
Model 6482 Dual-Channel Picoammeter / Voltage Source Reference Manual Section 1: Getting Started
3. Select BENCH or GPIB defaults (see Table 1-2 for specifics), and then press the ENTER key to
complete the process.
Table 1-2
Factory default settings
Setting* BENCH default GPIB default
A/D Controls:
Auto-zero
Line frequency
Data store
Display digits
Display mode
Filter:
Average mode, state*
Average filter count*
Advanced state, tolerance. *
Median filter rank, state*
GPIB address
Ground connect
Limit tests:
H/W** limits (1 and 2):
Control
Fail-mode
S/W** limits (3 to 6):
Control
Feed
Math function and units:
M factor (gain)
B factor (slope)
State
Numbers
Output:
Output enable
Enable
No effect
No effect
5.5
Dual-channel
Off
Repeat, disabled
10
Off, 5%
0, off
No effect
Disabled
Disabled
In compliance
Disabled
Channel 1 measure
MX +B, MXB
1
0
Disabled
No effect
Off
Disabled
On
No effect
No effect
5.5
Dual-channel
Off
Repeat, disabled
10
Off, 5%
0, off
No effect
Disabled
Disabled
In compliance
Disabled
Channel 1 measure
MX + B, MXB
1
0
Disabled
No effect
Off
Disabled
* Settings are for both channel 1 and channel 2.
** H/W: hardware; SW: software
To Next Page
Loading...
