Keithley 6482 - Remote Setups

1-14 Return to Section Topics 6482-901-01 Rev. A / August 2012
Section 1: Getting Started Model 6482 Dual-Channel Picoammeter / Voltage Source Reference Manual
Remote setups
You can also save and recall setups from a remote interface using the following SCPI commands:
• Save and recall user setups using *SAV and *RCL (see Section 14).
• Restore GPIB defaults using *RST (see Section 14).
• Restore bench defaults using :SYSTem:PRESet (see Section 16).
• Save the power-on configuration using :SYSTem:POSetup (see Section 16).
Power-on default
Ranging (measure):
Autorange
Upper limit
Lower limit
Rel:
Value
RS-232
Source delay:
Autodelay
Triggering:
Arm layer:
Event
Count
Timer
Input line
Output trigger
Trigger layer:
Event
Count
Timer
Input line
Output triggers
Delay
Voltage bias sources:
Amplitude
Range
Mode
Speed
Sweep:
Start
Stop
Step
Direction
Sweep count
Sweep points
Source ranging
Triggered source:
Control
Amplitude
No effect
Enabled
20 mA
2 nA
Off
0.0
No effect
1 ms
Enabled
Immediate
1
0.1
1
Line #2, off
Immediate
1
0.1
1
Line #2, all off
0.0 sec
0 V
10 V
Fixed
1 PLC
None
0 V
0 V
0 V
Up
1
3000
Best fixed
Disabled
0
No effect
Enabled
20 mA
2 nA
Off
0.0
No effect
1 ms
Enabled
Immediate
1
0.1
1
Line #2, off
Immediate
1
0.1
1
Line #2, all off
0.0 sec
0 V
10 V
Fixed
1 PLC
None
0 V
0 V
0 V
Up
1
3000
Best fixed
Disabled
0
Table 1-2 (cont.)
Factory default settings
Setting* BENCH default GPIB default
* Settings are for both channel 1 and channel 2.
** H/W: hardware; SW: software