FLUORESCENT LAMP HOLDER/LIGHT STARTER
SOCKET REPLACEMENT
The lamp holder and the light starter socket are located on the lamp channel assembly.
40 MAINTENANCE & REPAIR
1. Disconnect the power to the cabinet.
2. Remove the lids from the cabinet.
3. Remove the fluorescent bulbs.
4. Remove the screws holding the stainless steel
countertop in place. The screws are located
under the inside length of the top of the server
side of the cabinet.
5. Lift the stainless steel top off of the cabinet. Set
it aside. (FIG. 1)
6. For both the lamp holder and the starter socket,
remove the screws holding the part in place.
(FIG. 4-D) Remove the tape holding the wires to
the channel frame. (FIG. 2)
7. Disconnect the lead wires at the butt splice
connector. (FIG. 2-C)
8. Replace part with correct new part number.
9. Replace screws removed in Step 4. (FIG. 4-D)
10. Connect white and blue lead wires to main wire
with butt connectors. Replace the tape holding
the wires to the lamp channel.
11. Replace the stainless steel top (FIG. 1) using
screws removed in Step 4.
12. Replace the starter.
13. Replace the bulbs (fluorescent).
14. Reconnect the power to the cabinet.
Dipping Cabinet 1298.02 2/3/03 1:14 PM Page 42
To Next Page
Loading...
Need help?
General
