Kemppi X5 FastMig - Page 52

X5 FastMig
Operating manual - EN
8. Press the wire inch button to drive the filler wire into the welding gun. Stop when the wire reaches the welding
gun's contact tip.
>> In X5 Wire Feeder 200 the wire inch button is located in the control panel.
Watch out for the wire when it reaches the contact tip and exits the gun.
9. Before welding, ensure that the welding parameters and settings on the control panel conform to your welding
setup.
>> Refer to "Using X5 Manual control panel" on page74 and "Using X5 Auto control panel" on page80 for more
information.
"Wire spool and hub (200)" on page11
© Kemppi
52
1920960 / 2144