Group ID List
The transceiver uses a Group ID configured in the Group ID List to initiate a Group Call in a DMR Conventional system.
The
desired Group IDs must be preconfigured using KPG-D1/ D1N for the transceiver to initiate a Group Call. A maximum
of 1,500 Group IDs can be configured in the Group ID List.
Table 1-9 Group ID List
Configuration Description
ID
A Group ID can be configured in the range between 000001 and FFFCDF (hexadecimal), between
1 and 16776415 (decimal), or “ALL”.
“ALL” allows initiation of a call to all groups.
ID Name
The caller’s ID Name is configured. A maximum of 14 characters can be configured for the ID
Name.
If the ID Name of the group is configured in the Group ID List, the ID Name appears when the
transceiver
receives a call. If the ID Name is not configured in the Group ID List, the Group ID List
number appears.
ID Mode
The permission or inhibition of transmission of the receiving party can be configured.
An ID for which “Receive Only” is configured for ID Mode does not appear on the ID selection
display in Group Call Mode, and a user cannot select the ID in Group Call Mode.
If the transceiver receives a call from an ID for which “Receive Only” is configured for ID Mode,
the
caller’s ID Name appears. In this case, a user cannot initiate a call to the party even if the user
attempts to respond by pressing the PTT switch.
Alert Tone
The tone type sounding from the transceiver can be configured for a Group Call from the Group
IDs registered in the Group ID List.
Alert LED Color
The color of flashing LED can be configured for a Group Call from the Group IDs registered in the
Group ID List.
Note
To use Alert LED Color, Selective Call Alert LED needs to be enabled.
Configuration using KPG-D1/ D1N
Configuring Group ID List ( Transceiver Settings > DMR > Group ID List)
Display When the Transceiver Receives a Group Call (Unit ID Display on Group Call)
Unit ID Display on Group Call is the function to display the Unit ID of the transmitting transceiver when the transceiver
receives a Group Call.
If this function is enabled, the ID Name of the transmitting transceiver is displayed when the transceiver receives a Group
Call. (Refer to Receiving a Group Call.)
Configuration using KPG-D1/ D1N
Configuring Unit ID Display on Group Call ( Transceiver Settings > DMR > DMR Information > General)
1 DMR CONVENTIONAL SYSTEM
1.7 Making a Group Call
DMR FUNC (K, F)/Ver 2.20 33
CONTENTS INDEX