Kenwood NX-5200K3 Function Reference

Note
0
If Busy LED is enabled, the LED lights green when the transceiver is receiving. (Refer to Common FUNC Busy LED.)
0
If Alert Tone is configured to sound when receiving, an Alert Tone will sound. (Refer to Transceiver behavior when
receiving a Group Call.)
0
If Selective Call Alert LED or Optional Signaling LED is enabled, the LED flashes when the transceiver is receiving.
(Refer to Transceiver behavior when receiving a Group Call.)
0
The transceiver can record the receipt of a Group Call. The record can be checked in Stack Mode. (Refer to Common
FUNC Viewing the Receive History (Stack).)
0
If Group
ID Scan (DMR) is enabled, the transceiver is on standby to receive a Group Call from all Group IDs configured
in the Group ID List. (Refer to Group ID Scan (DMR).)
0
The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when
receiving a Group Call. (Refer to Sending the Received Unit ID from the Communication Port (Unit ID Serial Output).)
Transceiver behavior when receiving a Group Call
0
Alert Tone
If the received Group ID is configured in the Group ID List, an Alert Tone sounds from the transceiver according to the
configuration for Alert Tone
of the corresponding Group ID.
However, if “Common” is configured for Alert Tone in the Group ID List, or if the received Group ID is not configured in
the Group ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert Tone (Group
Call) used in common in a DMR Conventional system.
0
Selective Call Alert LED
If the received Group ID is configured in the Group ID List, the LED blinks according to the configuration for Alert LED
Color of the corresponding Group ID.
However, if “Common” is configured for Alert LED Color of the Group ID List, or if the received Group ID is not configured
in the Group ID List, the LED blinks according to the configuration in Alert LED Color (Group Call) used in common in
a DMR Conventional system.
0
Optional Signaling LED
If Optional Signaling LED is enabled, the LED flashes in yellow. However, when Selective Call Alert LED is enabled,
LED will flash in accordance with the configuration of Selective Call Alert LED.
Also, when the transceiver key is operated while the LED flashes according to the Selective Call Alert LED configuration,
the LED flashes in yellow if the matching state of Optional Signaling persists.
Configuration using KPG-D1/ D1N
0
Configuring Selective
Call Alert LED to be enabled or disabled (
Transceiver Settings > DMR > DMR Information
> Conventional)
0
Configuring Optional
Signaling LED to be enabled or disabled (
Transceiver
Settings > DMR > DMR Information
> Conventional)
0
Configuring Alert Tone/ Alert LED Color (Group ID List) (
Transceiver Settings > DMR > Group ID List)
0
Configuring Alert Tone (Group Call) used in common in a DMR Conventional system ( Transceiver Settings >
DMR > DMR Information > Conventional > Alert Tone)
0
Configuring Alert LED Color (Group Call) used in common in a DMR Conventional system ( Transceiver Settings
> DMR > DMR Information > Conventional > Alert LED Color)
1 DMR CONVENTIONAL SYSTEM
1.7 Making a Group Call
DMR FUNC (K, F)/Ver 2.20 32
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English