CONFigure:STRain:FULL:BENDing:POISson [{<gage_factor> | MIN | MAX | DEF}, [{<poisson_ratio> |
MIN | MAX | DEF}, [{<range> | MIN | MAX | DEF}, [{<resolution> | MIN | MAX | DEF},]]]]] (@<ch_list>)
Only supported on DAQM900A, DAQM901A, DAQM902A, and DAQM908A multiplexer modules.
Configures the channels for full bending poisson bridge strain gage measurements, but they do not initiate the
scan. This command redefines the scan list.
The CONFigure command does not place the instrument in the "wait-for-trigger" state. Use the INITiate or READ?
command in conjunction with CONFigure to place the instrument in the "wait-for-trigger" state.
Parameter Typical return
<gage_factor> = Any numeric value between 0.5 and 5
Default = 2
<poisson_ratio> = Any numeric value between -0.9999 and +0.5
Default = 0.3
<range> = {Auto | 100 mV | 1V | 10 V | 100V | 300V}
Default = AUTO
<resolution> = 1 PLC (0.000003 x Range)
(none)
Configures a full bending poisson bridge strain gage measurement on channel 101:
CONF:STR:FULL:BEND:POIS (@101)
Keysight DAQ970A/DAQ973A Programming Guide 101
2 SCPI Programming
To Next Page
Loading...
Need help?
General
