CONFigure:STRain:QUARter {<gage_factor> | MIN | MAX | DEF}, [{<range> | MIN | MAX | DEF}, [{<res-
olution> | MIN | MAX | DEF},]]]] (@<ch_list>)
Only supported on DAQM900A, DAQM901A, DAQM902A, and DAQM908A multiplexer modules.
Configures the channels for quarter bridge strain gage measurements, but they do not initiate the scan. This com-
mand redefines the scan list.
The CONFigure command does not place the instrument in the "wait-for-trigger" state. Use the INITiate or READ?
command in conjunction with CONFigure to place the instrument in the "wait-for-trigger" state.
Parameter Typical return
<gage_factor> = Any numeric value between 0.5 and 5
Default = 2
<range> = {Auto | 100 mV | 1V | 10 V | 100V | 300V}
Default = AUTO
<resolution> = 1 PLC (0.000003 x Range)
(none)
Configures a quarter bridge strain gage measurement on channel 101:
CONF:STR:QUAR (@101)
102
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
