LXI:RESet
Resets LAN interface to a known operating state, beginning with DHCP, and clears the Web Interface password. If
DHCP fails, it uses Auto-IP.
Parameter Typical return
(none) (none)
Resets the LANinterface: LXI:RES
– Depending on your network, the LAN interface may take several seconds to restart after this command is sent.
– If the LAN interface or specific LAN services (VXI-11, Sockets, and so on) have been disabled by SYSTem:COMMu-
nicate:ENABle, you must separately re-enable the interface or services and cycle instrument power for the LAN
to be operational.
LXI:RESTart
Restarts the LAN interface with the current settings as specified by the SYSTem:COMMunicate:LAN commands.
Parameter Typical return
(none) (none)
Restart the LANinterface: LXI:REST
– Depending on your network, the LAN interface may take several seconds to restart after this command is sent.
– If the LAN interface or specific LAN services (VXI-11, Sockets, and so on) have been disabled by
SYSTem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle instrument
power for the LAN to be operational.
162
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
Need help?
General
