OUTPut:ALARm:CLEar:ALL
Only supported on multiplexer modules (DAQM900A, DAQM901A, DAQM902A, and DAQM908A) and
DAQM907A multifunction module.
Clears the state of all four alarm output lines.
Parameter Typical return
(none) (none)
Clears all four alarm output lines: OUTP:ALAR:CLE:ALL
– A Factory Reset (*RST command) clears all four alarm outputs but does not clear the alarm queue in either con-
figuration.
– You can manually clear the output lines at any time (even during a scan) and the alarm data in reading memory is
not cleared. However, data is cleared when you initiate a new scan.
OUTPut:ALARm{1|2|3|4}:CLEar
Only supported on multiplexer modules (DAQM900A, DAQM901A, DAQM902A, and DAQM908A) and
DAQM907A multifunction module.
Clears the state of a specified alarm output line.
Parameter Typical return
(none) (none)
Clears output line on alarm 2: OUTP:ALAR2:CLE
– A Factory Reset (*RST command) clears all four alarm outputs but does not clear the alarm queue in either con-
figuration.
– You can manually clear the output lines at any time (even during a scan) and the alarm data in reading memory is
not cleared. However, data is cleared when you initiate a new scan.
Keysight DAQ970A/DAQ973A Programming Guide 199
2 SCPI Programming
To Next Page
Loading...
Need help?
General
