[SENSe:]DIGital:DATA[:BYTE]? (@<ch_list>)
[SENSe:]DIGital:DATA:WORD? (@<ch_list>)
Only supported on DAQM907A multifunction modules (channel 01 and 02).
Configures the specified channels as inputs and reads an 8-bit byte or a 16-bit word digital pattern from the spe-
cified digital input channels.
Parameter Typical return
(none) (none)
Reads the value on digital channel: DIG:DATA:WORD?
– To read both ports simultaneously (WORD), you must send the command to channel 01 (LSB).
– The output from this command is affected by the FORMat:READing commands.
Keysight DAQ970A/DAQ973A Programming Guide 225
2 SCPI Programming
To Next Page
Loading...
