SYSTem:CPON {<slot> | ALL}
Resets the module in the specified slot to its power-on state (CPON means "card power on"). This opens all channels
on the module. On the DAQM907A multifunction module, this also configures the digital I/O ports as inputs and
sets the DAC outputs to voltage mode (if not locked) and the output level to 0.
Parameter Typical return
<slot> = {1|2|3}
ALL = All three slots
(none)
Resets module in slot 2: SYST:CPON 2
Resets module in all three slots: SYST:CPONALL
Modules used are affected, as below:
Module Effect
DAQM900A If any channel is configured for a measurement, this command has no effect. If no channel is
configured, this command opens all channels.
DAQM901A If any channel is configured for a measurement, this command has no effect. If no channel is
configured, this command opens all channels.
DAQM902A If any channel is configured for a measurement, this command has no effect. If no channel is
configured, this command opens all channels.
DAQM903A This command opens all channels.
DAQM904A This command opens all channels.
DAQM905A This command closes channels 11 and 21.
DAQM907A This command resets all channels not involved in scan to the power-on state.
DAQM908A If any channel is configured for a measurement, this command has no effect. If no channel is
configured, this command opens all channels.
– This command does not reset the internal DMM.
– The instrument will produce an error if you are actively scanning and try to execute a SYSTem:CPON for a card
that is involved in the scan.
Keysight DAQ970A/DAQ973A Programming Guide 307
2 SCPI Programming
To Next Page
Loading...
Need help?
General
