SYSTem:BEEPer[:IMMediate]
Issues a single beep.
Parameter Typical return
(none) (none)
Issues a single beep: SYST:BEEP
– Programmed beeps may be useful for program development and troubleshooting.
– You can issue a beep with this command regardless of the current beeper state (SYSTem:BEEPer:STATe com-
mand).
SYSTem:BEEPer:STATe {OFF | ON}
SYSTem:BEEPer:STATe?
Enables (On) or disables (Off) the beep heard during measurements, or when an error is generated from the front
panel or remote interface.
Parameter Typical return
{OFF|ON}
Default: ON
0 (OFF) or 1 (ON)
Disable beep heard: SYST:BEEP:STATEOFF
– This setting will not affect the front panel key click (SYSTem:CLICk:STATe command).
– A beep is always emitted (even with beeper state OFF) when SYSTem:BEEPer is done.
– The setting is non-volatile, and does not change when power has been off, after a Factory Reset (*RST com-
mand) or after an Instrument Preset (SYSTem:PRESet command).
SYSTem:CLICk:STATe {OFF | ON}
SYSTem:CLICk:STATe?
Enables (On) or disables (Off) the click heard when knob is turned or keys are pressed.
Parameter Typical return
{OFF | ON}. Default: ON{OFF|ON}
Default: ON
0 (OFF) or 1 (ON)
Disable click heard: SYST:CLIC:STATEOFF
– The setting is non-volatile, and does not change when power has been off, after a Factory Reset (*RST com-
mand) or after an Instrument Preset (SYSTem:PRESet command).
306
Keysight DAQ970A/DAQ973A Programming Guide
2 SCPI Programming
To Next Page
Loading...
Need help?
General
