ARM3:SOURce {IMMediate | SWEep}, (@<ch_list>)
ARM3:SOURce? (@<ch_list>)
Sets the arm source on the specified channels.
This SCPI is only supported on the DAQM909A Digitizer module.
Parameter Typical return
{IMMediate | SWEep}
Default = IMMediate
IMM or SWE
Sets the arm source as IMMediate on digitizer channel 201
ARM3:SOUR IMM,(@201)
– For the SWEep source, the arm event occurs at every start of the sweep of the scan list when scanning using
multiplexer modules or the multifunction module.
– As DMM digitize mode does not generate arm event, the SWEep source is not allowed in DMM digitize mode. It
will generate the system error "Settings conflict; SWEep arm source not allowed in DMM digitizing mode".
Keysight DAQ970A/DAQ973A Programming Guide 57
2 SCPI Programming
To Next Page
Loading...
