Typical Characteristics
Tolerance % E36102A E36103A E36104A E36105A E36106A
Resolution
Program Voltage 360 μV 1.2 mV 2.1 mV 3.6 mV 6.0 mV
Current 300 μA 120 μA 60 μA 36 μA 24 μA
Readback Voltage 240 μV 800 μV 1.4 mV 2.4 mV 4.0 mV
Current 200 μA 80 μA 40 μA 24 μA 16 μA
Small Current 5 μA 960 nA 280 nA 180 nA 120 nA
Max. Small Curr. 20 mA 8 mA 4 mA 3 mA 2 mA
Program (Meter) Voltage 1 mV 1 mV 2 mV 3 mV 6 mV
Current 1 mA 1 mA 1 mA 1 mA 1 mA
Readback (Meter) Voltage 1 mV 1 mV 1 mV 3 mV 6 mV
Current 1 mA 1 mA 1 mA 1 mA 1 mA
Small Current 1 μA 1 μA 1 μA 1 μA 1 μA
Max. Small Curr. 20 mA 8 mA 4 mA 3 mA 2 mA
Ripple and Noise (20 Hz to 20 MHz)
Current RMS 2 mA 1 mA 400 μA 200 μA 160 μA
Overvoltage Protection (OVP) and Overcurrent Protection (OCP) Accuracy ± (% of output + offset)
Overvoltage protection (OVP) 0.20% + 0.5 V 1.5 V 3 V 5 V 8 V
Activation Time (average time for the output to start to drop after OVP or OCP condition occurs)
Overvoltage protection (OVP) < 1.5 ms when the trip voltage is greater than or equal to 3 V
Overcurrent protection < 1.5 ms
Command Processing Time < 10 ms
Programming Temperature Coefficient per ºC (% output + offset)
Voltage 0.005% 180 μV 600 μV 1.05 mV 1.8 mV 3.0 mV
Current 0.01% 250 μA 100 μA 50 μA 60 μA 40 μA
Readback Temperature Coefficient per ºC (% output + offset)
Voltage 0.005% 12 μV 40 μV 70 μV 120 μV 200 μV
Current 0.01% 250 μA 100 μA 50 μA 30 μA 20 μA
Remote Sense Output can function as described with up to a 1-V drop per load lead.
Up/down Programming Settling Time to Within 1% of Total Excursion
Up, full load 25 ms 50 ms 50 ms 50 ms 100 ms
Up, no load 25 ms 50 ms 50 ms 50 ms 100 ms
Down, full load 25 ms 25 ms 25 ms 30 ms 35 ms
To Next Page
Loading...
Need help?
General
