Safety and Regulatory Information
Safety Considerations
The following general safety precautions must be observed during all phases of operation, service, and
repair of this instrument. Failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture, and intended use of the instrument.
Keysight Technologies assumes no liability for the customer's failure to comply with these requirements.
BEFORE APPLYING POWER
Verify that the product is set to match the available line voltage and that the correct fuse is
installed. Use the label on the bottom of the instrument to configure the power.
See Options and Fuse Information for additional details.
GROUND THE INSTRUMENT
This product is a Safety Class I instrument (provided with a protective earth terminal). To
minimize shock hazard, the instrument chassis and cabinet must be connected to an
electrical ground. The instrument must be connected to the AC power supply mains
through a three-conductor power cable, with the third wire firmly connected to an
electrical ground (safety ground) at the power outlet. Any interruption of the protective
(grounding) conductor or disconnection of the protective earth terminal will cause a
potential shock hazard that could result in personal injury. If the instrument is to be
energized via an external autotransformer for voltage reduction, be certain that the
autotransformer common terminal is connected to the neutral (earthed pole) of the AC
power lines (supply mains).
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE OR WET ENVIRONMENTS
Do not operate the device around flammable gases or fumes, vapor, or wet environments.
To Next Page
Loading...
Need help?
General
