Keysight E5260/E5270 Programming Guide, Edition 4 4- 17
Command Reference
Command Reference
AAD
This command is available for the Keysight E5270B, and is used to specify the A/D
converter (ADC) type, high-speed or high-resolution, for each measurement
channel.
This command setting is ignored by the pulsed spot, pulsed sweep, and staircase
sweep with pulsed bias measurements.
Execution
Conditions
Enter the AIT command to set up the ADC.
This command is not available for the Keysight E5260 series.
Syntax AAD chnum[,type]
Parameters chnum : Measurement channel number. The value must be slot number where
the module has been installed. Integer expression. 1 to 8 (1 and 5 are
not available for HPSMU). See
Table 4-1 on page 4-9.
type : Type of the A/D converter. Integer expression. 0 or 1.
• 0: High-speed ADC (default setting). For high speed measurement.
• 1: High-resolution ADC. For high accurate measurement.
Example
Statements
OUTPUT @E5270;"AAD 1,0"
OUTPUT @E5270;"AAD 1,1"
To Next Page
Loading...
Need help?
General
