1 Getting Started
32 Keysight U1251B and U1252B User’s and Service Guide
Button Function when pressed for less than 1 second Function when pressed for more than 1 second
4
scrolls through the measuring function(s) at a
particular rotary switch position.
enters Log Review mode. Press
to switch to manual or interval logging data. Press
or to view first or last logged data respectively.
Press or to scroll up or down logged data.
Press for more than 1 second to exit mode.
5
scrolls through available measuring ranges
(except when rotary switch is set at or at Hz [for
U1252B] position)
[b]
.
sets to Auto Range mode.
6
scrolls through available dual-combination
displays (except when rotary switch is set at or
TEMP or Hz [for U1252B] position, or when meter is in
1 ms peak hold or dynamic recording mode)
[c]
.
exits Hold, Null, Dynamic Recording, 1 ms
Peak Hold and dual display modes.
7 enters Frequency Test mode for current or voltage
measurements. Press to scroll through
frequency (Hz), duty cycle (%) and pulse width (ms)
functions. In duty cycle (%) and pulse width (ms) tests,
press to switch to positive or negative pulse.
enters logging mode. In manual data logging,
press to log data manually into memory. In
automatic data logging, data logs automatically
[a]
.
Press for more than 1 second to exit auto data
logging mode.
Notes for keypad descriptions and functions:
[a] See Table 4-1 on page 103 for details of available options.
[b] When rotary switch is at , press to switch to ºC or ºF display. When rotary swtich is at Hz, press to switch to division
of signal frequency by 1 or 100.
[c] When rotary switch is at , ETC is ON by default. You may press to disable ETC (Environment Temperature Compensation),
will appear on display. For pulse and duty cycle measurement, press to switch trigger slope to positive or negative. When meter is
in peak or dynamic-recording mode, press to restart 1 ms peak hold or dynamic recording mode.
Table 1-2 Keypad descriptions and functions (continued)
To Next Page
Loading...
