KI ROGUE 2 - Luggage Carrier

33
Luggage Carrier
NOTE: There are different sizes of clamps to fit all types of chairs and configurations. The carrier
can be mounted to the frame or footrest tube on Rigid chairs. The installation is the same whether it
is being installed on the frame or footrest tubes.
1. Install luggage carrier fork (B) and clamp (E) by installing two screws (A) and barrel nut (C) through the
clamp and fork using two 4mm Allen wrenches.
2. Secure the clamp in the desired location by installing and tightening the screw (F) and nut (D) on the
backside of the clamp using a 5mm Allen wrench.
NOTE: The nut for the backside screw goes into a recess in the clamp. Ensure that nut stays in
place.
3. Repeat on opposite side.
Using the Luggage Carrier
1. Operating position for the luggage carrier is when the forks are folded down (See image below). The
max weight capacity is 55lbs.
2. When not in use, fold the luggage carrier up.
Assembled
A
B
CD
E
E
F
A
Folded Up
Operating Position