44
Transit
3. Install new backrest by installing pivot (F) into new backrest tubes and securing with bolt (E), back plate
(D), two saddles (C), washer (B) and nut (A) using a 5mm Allen wrench and an 8mm wrench. Repeat on
opposite side.
4. Install bolt (G), lock washer (F) and strike hex (D) using a 4mm Allen wrench and a 10mm wrench.
5. Install backrest release bar (N) and secure with screw (C) using a Phillips screwdriver. Repeat on
opposite side.
A
B
C
D
C
E
F
G
H
I
J
B
K
L
M
A
B
C
C
D
E
F
F
G
H
H
I
I
Original Backrest Design
New Backrest Design
To Next Page
Loading...