Safety features of your vehicle
143
Seat
Removal and reinstallation (if
equipped)
僅 To remove the headrest, raise it as far
as it can go then press the release
button (1) While pulling the headrest
upward (2).
僅 To reinstall the headrest, put the
headrest poles (3) into the holes while
pressing the release button (1).
Then adjust it to the appropriate height
and ensure that it locks in position.
Armrest (if equipped)
To use the armrest, pull it forward from
the seatback.
Folding the rear seat (if
equipped)
The rear seatbacks can be folded to
facilitate carrying long items or to
increase the luggage capacity of the
vehicle.
Folded Seatback
Do not sit on folded down seatbacks.
The purpose of the fold-down rear seat
-
backs is to allow you to carry longer
objects that could not otherwise be
accommodated.
僅 Never allow a passenger to sit on top
of the folded down seatback while the
car is moving. This is not a proper
seating position since the seat has
important crash protection features
and seat belts are not available in this
seat configuration.
僅 To reduce the risk of injury caused by
sliding cargo within the passenger
compartment of the vehicle, objects
carried on the folded down seatback
should not extend higher than the top
of the front seats.
To fold down the rear seatback:
1. Set the front seatback to the upright
position and if necessary, slide the
front seat forward.
2. Lower the rear headrests to the lowest
position.
ODL3A030026
ODL3A030027
To Next Page
Loading...
Need help?
General
