59
8
8
Maintenance Light bulbs
Light bulbs
Light bulbs are installed in various parts
of the vehicle to provide lighting inside
and outside the vehicle as well as to alert
other vehicles.
Bulb replacement precaution
Please keep extra bulbs on hand with
appropriate wattage ratings in case of
emergencies.
Refer to "Bulb wattage" on page 9-7.
When changing lamps, first turn off the
vehicle at a safe place, firmly apply the
parking brake and detach the battery's
negative (-) terminal.
Working on the lights
Prior to working on the light,
(1) Firmly apply the parking brake
(2) Turn the ENGINE START/STOP but
-
ton to the OFF position
(3) Turn off the lights to avoid sudden
movement of the vehicle and burning
your fingers or receiving an electric
shock.
Use only bulbs of the specified wattage.
Light replacement
Be sure to replace the burned-out bulb
with one of the same wattage rating.
Otherwise, it may cause damage to the
fuse or electric wiring system.
Fully install light bulbs and any parts
used to secure them. Failure to do so
may result in heat damage, fire, or water
entering the headlight unit. This may
damage the headlights or cause con
-
densation to build up on the lens. To
prevent damage or fire, make sure bulbs
are fully seated and locked.
Headlamp Lens
To prevent damage, do not clean the
headlamp lens with chemical solvents or
strong detergents.
僅 If the light bulb or lamp connector is
removed while the lamp is still on, the
fuse box's electronic system may log
it as a malfunction. Therefore, a lamp
malfunction incident may be recorded
as a Diagnostic Trouble Code (DTC) in
the fuse box.
僅 It is normal for an operating lamp to
flicker momentarily. This is due to a
stabilization function of the vehicle's
electronic control device. If the lamp
lights up normally after momentarily
blinking, then it is functioning as nor
-
mal.
However, if the lamp continues to
flicker several times or turns off com
-
pletely, there may be an error in the
vehicle's electronic control device.
Please have the vehicle checked by
an authorized Kia dealer immediately.
Have the headlight aiming adjusted by
an authorized Kia dealer after an acci
-
dent or after the headlight assembly is
reinstalled.
You can find moisture inside the lens of
lamps after a car wash or driving in the
rain. It is a natural event caused by the
To Next Page
Loading...
Need help?
General
